BDS Suspension 6.5" Coilover Conversion Lift Kit for 2020+ Chevy Silverado 2500 with Fox Shocks

SPECIFICATIONS

• Front Lift Method : Coil-Over
• Rear Lift Method : Block
• Shocks Included : Yes
• Front Lift Height : 6.5"
• Rear Lift Height : 5"

RECOMMENDED TIRES AND WHEELS

• 38x13.5 w/ 20x9 and 5.5" back spacing
  *Trimming may be required*

IMPORTANT NOTES

1. Models with two-piece rear drive shafts will require a carrier bearing drop kit. (BDS121612)
2. Requires frame bracket modification.
3. Disassembly/assembly of the factory torsion bar system requires the use of a special unloading tool. The GM specified tool # is CH48809.
4. Compatible with diesel models ONLY. Works with standard or AT4 diesel models.
5. Some minor trim will be required with certain wheel/tire combination. This is normal with most aftermarket tire/wheel fitment on Chevy/GM trucks. Trimming will normally include the bottom edge of the inner fender shrouds and/or lower corner of front bumper valance. As a rule of thumb, deeper backspacing and shorter/narrower tires will reduce/eliminate trimming required. Further trimming tips are included at the end of this instruction sheet.
6. Factory 17-18" wheels cannot be reinstalled due to tie rod end interference, stock 20" wheels can be reinstalled with up to a 37x12.50 tire.
7. In some cases vehicles used in 4WD on the highway regularly could potentially experience a minor front driveline vibration. If this occurs we recommend replacing the front driveshaft with a dual Cardan style driveshaft.
8. Coilover coil has a large amount of preload, a coil spring compressor must be used to remove the coil from the coilover. Failure to use a coil spring compressor may result in death or injury.
9. Do not increase coilover preload.
10. For DRW models, use the w/ overload rear lift option.

FITMENT

View complete Vehicle Fitment Information here.

INSTALLATION

Installation Guide: Download

Estimated Time: 14 hours

Difficulty Level: Moderately-Hard